![]() ![]() If I had a broken wire the bulbs should be out all the way to the end of the string. So I convinced myself that it can't be a dead bulb since the good part of the string stays lit even if a bulb is removed. Also there are three wires along the whole string except for when you get to the end where the cylindrical connectors are only two wire connectors. ![]() This would lead me to believe that these bulbs are connected in parallel since removing one bulb did not kill the whole string. I randomly remove one of the working bulbs in the good section and it had no effect on the rest of the string Everything stayed lit before and after the dead section. id try and replace the first dead bulb, or if you. as the link cannot carry on further than the busted bulb. I have 200 feet of lights with about 10 ft in the middle that are dark. ive never worked with that brand of lighting before, but usually with christmas lights, the are all interlinked as a loop circuit, so the first one that is out is usually the cause of the problem. For us, the pair part was a key, and through a little trial and error, we found out that the bulb. I have seen people trouble shooting these types of lights and they are always looking for a bad bulbs. The short version of that article is that the way these light strands work is that the light bulbs are connected in series and in parallel, and the most important thing to know is that the bulbs seem to be connected in pairs. In the middle of this run I have about 10 bulbs on both sides of one of these junctions that are not lit. The sets are strung together by joining a two conductor cylindrical connector that is on the end of the set. To cut Christmas lights that are wired in parallel, follow these three basic steps: Unplug the Christmas lights from the outlet. They are unusual in that there is a brick where they plug into 120 volt AC outlet that I assume is the AC to DC converter. This means that you can remove as many bulbs as you desire and cut the lights to any length without the risk of overloading or burning out the bulbs. I have a couple of hundred feet of LED Christmas lights surrounding my outdoor deck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |